ZyXEL Communications ZyWall 110 - The Service Group Summary Screen

Chapter 43 Object
ZyWALL USG Series User’s Guide
853
43.8.3 The Service Group Summary Screen
The Service Group summary screen provides a summary of all service groups. In addition, this screen
allows you to add, edit, and remove service groups.
To access this screen, log in to the Web Configurator, and click Configuration > Object > Service >
Service Group.
Figure 591 Configuration > Object > Service > Service Group
The following table describes the labels in this screen. See Section 43.8.3.1 on page 854 for more
information as well.
Starting Port
Ending Port
This field appears if the IP Protocol is TCP or UDP. Specify the port number(s) used by this service.
If you fill in one of these fields, the service uses that port. If you fill in both fields, the service uses
the range of ports.
ICMP Type This field appears if the IP Protocol is ICMP or ICMPv6.
Select the ICMP message used by this service. This field displays the message text, not the
message number.
IP Protocol
Number
This field appears if the IP Protocol is User Defined.
Enter the number of the next-level protocol (IP protocol). Allowed values are 1 - 255.
OK Click OK to save your changes back to the Zyxel Device.
Cancel Click Cancel to exit this screen without saving your changes.
Table 331 Configuration > Object > Service > Service > Edit (continued)
LABEL DESCRIPTION
Table 332 Configuration > Object > Service > Service Group
LABEL DESCRIPTION
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to be able to modify the entry’s settings.
Remove To remove an entry, select it and click Remove. The Zyxel Device confirms you want to remove
it before doing so.
References Select an entry and click References to open a screen that shows which settings use the entry.
# This field is a sequential value, and it is not associated with a specific service group.