2gig Technologies GO!control 2GIG-CNTRL2 Operation And User's Guide

11
Arming to Stay Mode
Use Stay Mode to arm the system when anyone will be staying home. Stay Mode normally has an
Entry Delay so someone with a User Code can re-enter without causing an alarm.
Close all protected perimeter doors and windows before arming.1.
Verify that the2.
button on the Control Panel is lit green indicating that the system is ready
to arm. The SECURITY button and ARM button on the display will also be green when all
sensors are closed.
From the Security Screen, or the Menu Screen, press 3. ARM.
If there are any open door or window sensors, the Bypass Screen will appear. Close •
all the sensors displayed or press BYPASS ALL to force bypass the displayed
sensors. NOTE: BYPASSED SENSORS WILL NOT BE ABLE TO TRIGGER AN ALARM.
To bypass sensors, you will need to enter a User Code unless •
the installer has set the system for “ Quick Bypass”.
On the Arming Screen, one check box option can be used with Stay Mode.4.
If no one is expected to re-enter, the system can be armed without an Entry •
Delay. All perimeter doors will trigger the alarm instantly. To arm with all
perimeter doors as instant, un-check the ENTRY DELAY option button.
Press 5. STAY to arm the system.
To arm the system, you may need to enter a User Code if your •
installer has turned off the system’s “ Quick Arming” feature.
The system will arm and show the 6. Exit Delay counting down. When the Exit Delay expires, the
system is fully armed in the Stay Mode.
Burglary Protection
The Security Screen
Quick Exit ButtonEntry Delay Check Box
The Arming Screen

2gig Technologies GO!control 2GIG-CNTRL2 Specifications

General

Brand	2gig Technologies
Model	GO!control 2GIG-CNTRL2
Category	Security System
Language	English