2gig Technologies GO!control 2GIG-CNTRL2 User Manual

43
Installer Set Options
Quick Arming
Quick Arming allows you to arm your system without having to enter a User Code. When you press
the STAY or AWAY button, the system will start to arm without requesting a User Code.
QUICK ARMING
❑ OFF ❑ ON (regular setting)
Quick Bypass
Normally sensors that are open at the time the system is armed will require force bypassing by
entering your User Code. The system can be set so a User Code is not required to bypass open
sensors when the system is armed.
QUICK BYPASS
❑ OFF (regular setting) ❑ ON
Quick Exit
The Quick Exit option allows you to start the Exit Delay while the system is armed. This allows you
to leave the premises without having to disarm and rearm the system. When the Quick Exit option is
on, a QUICK EXIT button will display on the security screen. Press the button to start the Exit Delay.
After Quick Exit, the system will fully re-arm in the mode that it was in before (Stay or Away Mode).
QUICK EXIT
❑ OFF ❑ ON (regular setting)
Auto Un-bypass
Normally, sensors manually bypassed with the User Toolbox will automatically have their bypasses
removed when the system is disarmed. The system can be set so sensors that have been manually
bypassed will stay bypassed until the bypass is manually removed.
AUTO UN-BYPASS
❑ OFF ❑ ON (regular setting)
Auto Stay
The Auto Stay option will change the arming mode if no one exits after arming the system in Away
Mode. When the system is armed in the Away Mode the Exit Delay will begin. With the Auto Stay
option on, if a designated exit/entry door does not open and close during the Exit Delay, the system
will arm in the Stay Mode instead of the Away Mode.
AUTO STAY
❑ OFF ❑ ON (regular setting)
Key Fob Arm/Disarm Sound
The system can be set so when it’s armed or disarmed by a wireless key fob, a beep will sound
through the internal and external sounders to indicate that the key fob’s signal was received. This
helps in installations where the Control Panel is not visible or there are no other system status
indications at the key fob’s location.
KEY FOB ARM/DISARM SOUND
❑ OFF (regular setting) ❑ ON

2gig Technologies GO!control 2GIG-CNTRL2 Specifications

General

Brand	2gig Technologies
Model	GO!control 2GIG-CNTRL2
Category	Security System
Language	English