2N IP Force 9151101W - Control

Installation manual 2N® IP Force

104 / 118
•
•
•
•
•
Mode Switching with 1 or 2-Button Models
In case your2N
®
IP Forcedevice is equipped with 1 or 2 buttons, you can
switch the modes using one button only.
Connect2N
®
IP Forceto the power supply (or, disconnect and reconnect it if already connected).
Wait for the first acoustic signal .
Pressthe first quick dialbutton 15 times.
The acoustic signal indicates mode switching.
Wait until the device is restarted automatically.
The static IP address mode will be switched into the dynamic IP address
mode and vice versa upon restart.
3.2 Control
This subsection describes how to control2N
®
IP Forcewhen viewed by an
external user.
Speed Dial Buttons
Press the speed dial buttons on the basic unit to make quick dialling for the
first 1, 2 or 4 positions (depending on the model type) in the telephone
•
Caution
The 15 times 1 sequence must be entered within 30 seconds after the first sound signal for security
reasons. The inter-digit delay may be 2 s at most.
