2N IP Uni - Configuration

Installation manual 2N® IP Uni
41 / 58
•
•
•
Green LED Red LED Status
on off Activated output
blinking blinking Programming mode – waiting for
initialisation
on blinking Error – wrong code received
Configuration:
Connect the2N
®
Security Relayto the properly set intercom switch output; refer
totheConfiguration Manual for 2N IP intercoms. Make sure that one LED at least on
the2N
®
Security Relayis on or blinking.
Press and hold the2N
®
Security RelayReset button for 5 seconds to put the devicein the
programming mode (both the red and green LEDs are blinking).
Activate the intercom switch using the keypad, telephone, etc. The first code sent from
theintercom will be stored in the memory and considered valid. After code initialisation,
the2N
®
Security Relaywill pass into the operational mode (the green LED is blinking).
•
Caution
In case of resetting the factory default settings on a device with a version of
firmware 2.18 or higher it is necessary to reprogram the
2N
®
Security Relay using the instructions above.

•
Tip
FAQ: 2N
®
Security Relay – what it is and how to use it with 2N IP intercom?
