3-80
Click Save Configuration. The Save Configuration Page opens.
Figure 3-87 Save Configuration Page
Click OK. The configuration is saved.
Resetting the Switch
The Reset Page restores the switch factory defaults.
To prevent the current configuration from being lost, use the Save Configuration Page to save all
user-defined changes to the flash memory before resetting the switch.
Click Administration > Reset. The Reset Page opens.
Figure 3-88 Reset Page
Managing System Files
The configuration file structure consists of the following configuration files:
z Startup Configuration File: Contains the commands required to reconfigure the switch to the same
settings as when the switch is powered down or rebooted. The Startup file is created by copying the
configuration commands from the running configuration file or by downloading the configuration file
from via TFTP or HTTP.
To Next Page
Loading...
