3Com 3CBLSF26PWRH - Configuring MAC Address Table

3-7
Figure 3-8 ARP Settings Summary Page
The ARP Settings Summary Page contains the following fields:
Table 3-7 ARP Settings Summary Page item description
Item Description
Interface Indicates the VLAN for which ARP parameters are defined.
IP Address Indicates the IP address, which is associated with the MAC Address.
MAC Address
Displays the station MAC address, which is associated in the ARP table
with the IP address.
Status
Displays the ARP table entry type. Possible field values are:
z Dynamic: Indicates the ARP entry is learned dynamically.
z Static: Indicates the ARP entry is a static entry.
Configuring MAC Address Table
MAC addresses are stored in either the static address or the dynamic address databases. A packet
addressed to a destination stored in one of the databases is forwarded immediately to the port.
The Dynamic Address Table can be sorted by interface, VLAN, and MAC address. MAC addresses are
dynamically learned as packets from sources arrive at the switch. MAC addresses are associated with
ports by learning the ports from the frames source address. Frames addressed to a destination MAC
address that is not associated with any port are flooded to all ports of the relevant VLAN.
Static addresses are manually configured. In order to prevent the bridging table from overflowing,
dynamic MAC addresses, from which no traffic is seen for a certain period, are erased.
This section includes the following sections:
z Adding MAC Addresses to the Address Table
z Defining Aging Time
z Removing MAC Addresses for the specific port
z Removing MAC Addresses from the Address Table
z Viewing Address Table Settings
z Viewing Port Summary Settings