3Com 3CBLSF26PWRH - Ping

5-9
View
User view
Parameter
interface-number: Ethernet port number
Description
Use the management-vlan port command to add Ethernet ports of the switch to the management
VLAN.
By default, all Ethernet ports of a switch belong to management VLAN 1.
Example
# Configure VLAN 10 as the management VLAN, and add Ethernet 0/1 through Ethernet 0/5 of the
switch to the management VLAN.
<Command-Line> management-vlan 10
<Command-Line> management-vlan port ethernet0/1 to ethernet0/10
<Command-Line> display management-vlan
VLAN ID: 10
IP Address: 192.168.0.241
Subnet Mask: 255.255.255.0
Tagged Ports: none
Untagged Ports:
Ethernet0/1 Ethernet0/2 Ethernet0/3
Ethernet0/4 Ethernet0/5 Ethernet0/6
Ethernet0/7 Ethernet0/8 Ethernet0/9
Ethernet0/10
ping
Syntax
ping [ -s packetsize ] [-c count ] ip-address
View
User view
Parameter
ip-address: Sets the source IP address to send the ICMP ECHO-REQUEST packets.
-s packetize: Specifies the size (in bytes) of each ICMP ECHO-REQUEST packet (excluding the IP and
ICMP headers), which ranges from 20 to 1,472 and defaults to 56 bytes.
-c count: Specifies how many times the ICMP ECHO-REQUEST packet will be sent. The count
argument is the times, which ranges from 1 to 4,294,967,295 and defaults to 5.
Description
Use the ping command to check the IP network connectivity and the reachability of a host.