3Com 4210 Release Notes

Switch 4210 V3.01.09 Release Notes
February 27, 2009 Page 10 of 43
Category Features
Loopback-detection Support
Port loopback test
(interloop and
exterloop)
Support
MAC Address Support MAC address learning automatically
Accord with IEEE 802.1D
Up to 8K MAC Addresses
Up to 1K static MAC Addresses
Support adding dynamic, static unicast MAC and black-hole MAC
Addresses
Flow-control Support IEEE 802.3x flow-control(full duplex)
Support Back-pressure based flow control(half duplex)
Updating Support updating through XModem, FTP(File Transfer Protocol) and
TFTP(Trivial File Transfer Protocol)
Management Support CLI
Support Telnet
Support Console
Support SNMP(Simple Network Management Protocol)
Support RMON(Remote Monitoring)1,2,3,9 group MIB
Support HGMP V2
Support QuidView network management
Support WEB network management
Support log
Support alarm
Support IPv6 management
Maintenance Support debugging
Support PING(Packet Internet Groper),Traceroute
Support remote maintenance via Telnet
Support VCT(Virtual Cable Test)
Support remote-ping
QoS/ACL 4 output queues per port
Support 802.1p priority, DSCP(Differentiated Services Codepoint
Priority)priority ,ip-precedence priority
Support WRR(Weighted Round Robin),HQ+WRR(High-Priority Queuing
+ WRR) queue-schedule
Support line-rate bi-direction per port, minimum granularity 64 Kbit/s

3Com 4210 Specifications

General

Model	3Com 4210
Category	Switch
Layer	Layer 2
VLAN Support	Yes
Switching Capacity	8.8 Gbps
Forwarding Rate	6.6 Mpps
Jumbo Frame Support	Yes
Power Supply	Internal
MAC Address Table Size	8000 entries
Features	Port Mirroring
Compliant Standards	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab
Management	Web-based, CLI