Switch 4210 V3.01.09 Release Notes
February 27, 2009 Page 22 of 43
(2) DCHP Snooping does not configure on the device. After user log in, change user IP by DHCP,
the device will force the user to log off.
(3) DCHP Snooping is configured on the device. After user log in, change user IP by DHCP, the
device won't force the user to log off.
After Modification:
After user log in, change user IP by any means of the 3 above, the device won't force the user to log
off.
In one word: after modified, in condition (1) and (2), the user state becomes from logging off to
remaining on line; in condition (3), the result doesn't change.
Configuration Changes in V3.01.04
None
Operation Changes in V3.01.04
1) The function of ignoring configuration is modified to take effect only once, while before it would
take effect all the time if configured.
Open Problems and Workarounds
LSOD08491
z First found-in version: V3.01.08
z Description:
Create a VLAN interface, then PING this VLAN interface on device. The PING result is bad.
z Workaround:
None
List of Resolved Problems
Resolved Problems in V3.01.09
LSOD08461
z First found-in version: V3.01.08
z Condition:
Connect two devices through link-aggregation ports. Enable LLDP on both devices. One of the link-
aggregation ports became link-down.
z Description:
The devices reboot abnormally.
To Next Page
Loading...
