3Com 4210 - Installing the Switch; Safety Information for Installation

Switch 4210 V3.01.09 Release Notes
February 27, 2009 Page 23 of 43
LSOD08410
z First found-in version: V3.01.08
z Condition:
The device will output log message when getting the abnormal status of POE card.
z Description:
The device may reboot with little probability.
LSOD08392
z First found-in version: V3.01.08
z Condition:
After a switch gets IP address through DHCP successfully, enable link-aggregation on manual mode,
and display link-aggregation verbose information.
z Description:
The devices reboot abnormally.
LSOD08510
z First found-in version: V3.01.08
z Condition:
The device connects with other device by 1000M fiber port. First configure “speed auto 100” and the
fiber port Link down, and then configure “undo speed”.
z Description:
The fiber port can’t Link up.
LSOD08639
z First found-in version: V3.01.08
z Condition:
Get the MIB node “dot1dTpFdbEntry” from the device by SNMP.
z Description:
The device returns error.
LSOD08628
z First found-in version: V3.01.08
z Condition:
Get the MIB node “lldpRemPortDescription” from the device by SNMP.
z Description:
The returned value is not equal to MIB node “ifDesc”.