3Com 4210 - Introduction to Non-PWR Switch Models; Switch 4210 9-port Front Panel

Switch 4210 V3.01.09 Release Notes
February 27, 2009 Page 14 of 43
Command Line Updates
Table 7 Command line updates
Version number Item Description
New commands
Command 1
Syntax:
attribute-ignore { standard | vendor vendor-id
} type type-value
undo attribute-ignore { all | standard | vendor
vendor-id }
View : radius scheme view
Parameter:
vendor-id: Specify the vendor ID of radius
attribute that should be ignored. Range from
1~16777215.
Type-value: Specify the type value of radius
attribute that should be ignored. Range from
1~255. The maximum configured counts of this
value are 8.
Description: It is used to configure the radius
attribute ignore.
Example:
# Configure ignore “81” standard attribute of radius
scheme “system”.
[4210]radius scheme system
[4210-radius-system]attribute-ignore standard type
81
Removed commands None
V3.01.09
Modified commands None
New commands Please refer to the manuals.
Removed commands None
V3.01.08
Modified commands None
V3.01.06
New commands
Syntax:
[undo]link-delay value
View : interface view
Parameter:
value: Specify the delay time.
Description: It is used to configure the link-down
delay time. Unit: second, Range: 2~10
Example:
# Configure delay time of Ethernet1/0/1 to 5