Switch 4210 V3.01.09 Release Notes
February 27, 2009 Page 40 of 43
Note:
After the terminal baud rate is modified, it is necessary to disconnect and then re-connect the terminal
emulation program to validate the new setting.
Step5 Select [Transfer\Send File] from the terminal window. Click <Browse> in the pop-up window and
select the software to be downloaded. Change the protocol name to Xmodem.
Figure 2 Send File
Step1 Click <Send> and the system will display the window as shown Figure 2.
Figure 3 Xmodem File Send
Step1 After the downloading of the program is completed, the screen will display the following information:
Loading ........................................................done
Please input a new file name :switch.bin/specify the file name in flash/
Writing flash................................................done
Please input the file attribute (main/backup/none):main /specify the file attribute/
To Next Page
Loading...
