ACFP Configuration Example 19
in network segment 192.168.2.0 (achieved by setting node
h3cAcfpRuleSrcIP) and source IP wildcard-mask is 0.0.0.255 (achieved by
setting node h3cAcfpRuleSrcIPMask) are matched, the rule row status is 4
(achieved by setting node h3cAcfpRuleRowStatus) and the other
parameters adopt the default values.
# Apply ACFP rules
Configure the ACFP policy through the MIB browser, where the policy
index is 1.1. Configure the Admin-Status as enable (achieved by setting
node h3cAcfpPolicyAdminStatus).
■ Verify the configuration.
Use the ping command to verify the connectivity between Host A and
Host C, Host B and Host C. The test results show that Host C can be
pinged through on Host A and Host C cannot be pinged through on Host
B.
To Next Page
Loading...
