47
7 ACSEI Client Configuration
Commands on the OSN|M
n
You can execute the following commands in any directory of the Linux
system. You can use the osm connect unit command in the switch’s user
view to enter the OSN|M’s Linux system. For description of the osm
connect unit command, refer to “osm connect unit” on page 31.
acsei-client debug disable
Syntax acsei-client debug disable
View Any directory of the Linux system
Parameters None
Description Use the acsei-client debug disable command to disable debugging for
the ACSEI client.
By default, debugging for the ACSEI client is disabled.
Examples # Disable debugging for the ACSEI client on unit 1.
<SW5500G> osm connect unit 1
Connected to OSM!
[root@localhost ~]# acsei-client debug disable
acsei-client debug enable
Syntax acsei-client debug enable
View Any Linux system directory
To Next Page
Loading...
