4 OSN|M Configuration
Commands
osm connect unit
Syntax osm connect unit unit-id
View User view
Parameters unit unit-id: Specifies a switch by its unit ID.
Description Use the osm connect unit command to switch from the command line
interface on the local switch to the Linux OS on the OSN|M. You can
specify the unit ID of the local switch or the unit ID of another switch in
the same fabric as the local switch.
Press Ctrl+K to return from the OSN|M’s Linux OS to the local switch’s
command line interface.
Only one user can switch to the OSN|M’s Linux OS at a time.
Examples # Switch from the local switch’s command line interface to the OSN|M’s
Linux OS on unit 1.
<SW5500G> osm connect unit 1
Connected to OSM !
# Press Enter after the above prompt is displayed. If the Linux OS is
running on the OSN|M, the operating interface is switched to the Linux
OS.
[root@localhost ~]#
# Press Ctrl+K to return to the local switch’s CLI.
<SW5500G>
To Next Page
Loading...
