3D Prototyping X1
18
per the following steps. We secure the parts to protect them during transportation. When
you receive the product, please loosen the rope, and take off the white cotton mat at the
bottom, shown in figure 3.3.1. Please save the foam and bind the parts as we did in the
event that you need to move or deliver the printer in the future.
Figure 3.3.1
1. Rope
2. White cotton mat
3.3.1. Connect power adapter and USB cable
As in Figure 3.3.1.1 below, connect the printer and your computer using the USB
connection on the side of the printer, and connect the power adapter to the power
interface on the side of the printer.
To Next Page
Loading...