3D Prototyping X1 - Loading Filament into the Printer

3D Prototyping X1
20
figure3.3.2.1
Second step: The Magnets makes it is easy to align the build plate, you just need to
fit the two notches in the plate onto the platform.
Figure 3.3.2.2
Third step, mounting the filament spool. Please note the direction.
figure3.3.2.3
3.3.4. Load filament
1. Check whether the end of the filament is straight.
2. Cut the end of the filament flat and push the end of the filament into one end of
the filament tube from the underside, and then pull it through to the extruder. See
figure3.3.4.1