3D Prototyping X1 - Frequently Asked Questions (FAQ); Troubleshooting Filament Sticking; Poor Print Adhesion or Warping Issues; Resolving Printer Connection Problems

3D Prototyping X1
56
A、 Check the connection of the power cable and USB data cable, and check if
the power button of the printer has been pressed.
B、 Change the port.
C、 Please try to connect again after the independent printing is finished.
D、 Install the drivers.
9. Contact Us
3D Prototyping Pty Ltd
48B Nariel Street
Albion
Qld
4010
Tel: 07 3262 9283
Email: sales@3dprototyping.com.au