3D Prototyping X1
24
4.2. Function area
Function bar contains two options, “Main” and “Setting”.
MAIN
The interface of “Main” is shown in the figure below, its function are as the follows.
1. Connect or disconnect with device.
2. Shutdown
3. Generate Gcode.
4 Start, pause printing.
5. Pause, recover printing
6. Choose “Control Panel” “Model Panel” or “shortcut folder”.
7. model editing
8. Open folder
figure4.2.0.1
Setting
The interface of “Setting” is shown in the figure below, its function are as the follows.
1. view
2. Model view
a) Show or hide the status bar.
b) Show or hide the title bar.
c) Show or hide the model face.
d) Show or hide lines.
e) Set model color.
3. Program
a) Select to query the temperature automatically.
b) Set the language.
4. Building
a) select to stop heating automatically after printing
b) select to shutdown printer automatically after printing
5. Hardware
a) Firmware update
b) set Z height
c) platform leveling
6. SD Card
a) Build from SD
b) save to SD
To Next Page
Loading...