3D Prototyping X1 - Panel Area Components

3D Prototyping X1
25
figure4.2.0.2
4.3. Panel Area
Panel area contains “Control panel”, “Model panel”, and “shortcut folders”.
 Control panel
You can only control the printer when software connecting with the printer under the
“Ready” status. Click “Control Panel” at the bottom of panel area or click “Control Panel”
under “Main” to open the panel.
figure4.3.1
The function of “Control panel” are as the follows.
1. Control move
a) Control the motion of platform
b) Control extruder
c) Control “Fan on” and “Fan off”
2. Control temperature