3D Prototyping X1 - Printer Installation and Setup; Printer Installation Guide; USB to Serial Driver Installation

3D Prototyping X1
5
Nozzle diameter 0.4mm
Move speed 60mm/s
Vertical print speed about 30cm³/hour
Positional accuracy 0.01mm
Consumable Materials PLA
Machine Dimension 300*320*390mm
Net Weight 9.5kg
Packing Size/weight 459*424*474mm/13.5kg
Connectivity USB, TF card
Nozzle 1
3. Installation
3.1. Printer installation
Within the CD is the printing software 3DSTART, driver, and STL models. 3DSTART
supports the operating system windows XP 32 bit and Win7 32/64bit (professional edition
or higher).
3.1.1. Install the driver of USB to serial port
(1) After connecting the device, if the hardware wizard pops up, you can install the
driver according to the wizard. If it fails to pop up, please check from Device Manager”
（from desktop, right click Computer-property->device manager）, and see whether there
is an unknown device (marked with yellow exclamation at the icon) in the “Device
Manager”, shown in the figure below.