3D Prototyping X1 - Print Settings and Preferences; GCode Generator Settings

58 pages

To Next Page

To Previous Page

3D Prototyping X1

6. Print setting preferences

6.1. Gcode generator setting

figure6.11

Usually, only Print mode needs to be adjusted. We suggest to use the defaulted setting for

printing, or, the extruder might get blocked with the filament.

There are 4 options to set the print resolution between 0.15mm to 0.35mm per layer. The

finer the layer, the better the quality, the stronger the printed part and the longer it takes to

print.

MODE-Fast: 0.35mm layer thickness；

MODE_Midium： 0.25mm layer thickness；

MODE-Quality： 0.15mm layer thickness；

MODE-Standard： 0.2mm layer thickness；