3D Prototyping X1
42
Support Mode
None support：There is no support generated.
Outside support：The support will be generated outside of the model
Full support：There will be outside and internal support generated.
Select add raft, there will be a model base generated.The raft helpf for good stability.
Thin-wall
Select Thin-wall, there is no internal support will be created, but only an external shell.
There is no top surface created only bottom surface. The layer thickness will be at
least 1 layer. The shell layer can be added by solid shell layer.
means 2 in actual will be created, 2 for 3, and the
like.
To Next Page
Loading...