3D Prototyping X1 - Setting the Z-Axis Height

3D Prototyping X1
48
6.4. set Z axis Height
Note：this setting can be only operated on online status。
1、 “setting”->“set height”, the below dialog box will pop up
2、 click “Z homing”
3、 first choose “Uninterrupted”, click Z+ will make the platform move fast, and then
choose “Fix move”1mm to make slight movement, making the platform moving close
to the nozzle until they meet each other.
4、 Click “Get current Z height ”to get the current Z axis height
5、 Click “apply” to finish the settings.
As the figure shows：
figure4.2.3
TIP :You may need to set Z height when models are not adhearing to the platform
properly, or are distorted.