3D Prototyping X1
37
figure5.6
When Generating and loading Gcode are finished (If check “Auto load GCode Language”
under the “Setting”), the printing time needed will appear in the interface.
figure5.7
9. Start to print. There are two ways to print model, including online print and
offline print.
Online print
If you choose the online print, you only need to click “Start” in the interface “Main”, then it
will start to print the model.
figure5.8
Click “Stop” to stop printing. After clicking “Stop”, it cannot restore and print
again.
To Next Page
Loading...