3D Systems CUBE - Unpack Your Cube

To Next Page

To Previous Page

UNPACK YOUR CUBE

NOTE: Keep all packing materials for future transport. Shipping the printer without

the original packing materials may damage the printer and void the manufacturer’s

warranty.

1. Pull the clips (A) and remove them from the top of the

printer box and open the box.

2. Remove the upper foam support.

3. Remove the printer from the box and remove the

protective bag from the printer. Place the printer on a

solid, level base.

NOTE: When installing the printer there must

be a minimum of 8” (203 mm) of space on top

and on either side of the printer.

NOTE: There must be a minimum of 4” (102

mm) space in front of and behind the printer.

Other manuals for 3D Systems CUBE