3D Systems CubePro Manual

Level The Print Jet Nozzle
Verify the Print Jet Nozzle Level
Leveling the print jet nozzles is very important to ensure quality prints especially after
replacing a print jet, an extruder assembly or the print pad.
The Print Jet Level Gap calibration file requires all cartridge bays to be loaded with the
same material type cartridges.
NOTE: Ensure the file used matches the printer model and the installed print
material type. All installed cartridges must be of the same material type.
(Ex. If the cartridge bays have ABS material cartridges installed, print the
ABS Level Gap calibration file.)
These files are available at www.3dsystems.com/shop/cubepro/downloads. The Level Gap
Calibration files are available from the Calibration Files download link in the Firmware and
Files section of the web page.
The file names are listed below:
PLA:
noz12_PLA_LEVELGap.cubepro (This file is for printing PLA on a CubePro Duo)
noz123_PLA_LEVELGap.cubepro (This file is for printing PLA on a CubePro Trio)
ABS:
noz12_ABS_LEVELGap.cubepro (This file is for printing ABS on a CubePro Duo)
noz123_PLA_LEVELGap.cubepro (This file is for printing ABS on a CubePro Trio)
Nylon:
noz12_NYL_LEVELGap.cubepro (This file is for printing nylon on a CubePro Duo)
noz123_NYL_LEVELGap.cubepro (This file is for printing nylon on a CubePro Trio)
Other files may be made available in the future.
Level Nozzle Calibration Print Overview
The following illustration demonstrates what you would see when the print jet nozzles are
properly leveled.

3D Systems CubePro Specifications

General

Product color	Black, White
Viewing window	Yes
Maximum extruder tip temperature	280 °C
Input current	6 A
AC input voltage	100-240 V
AC input frequency	50 - 60 Hz
Print technology	Plastic Jet Printing (PJP)
Printing material	ABS, Polylactic acid (PLA)
Layer thickness (max)	0.3 mm
Layer thickness (min)	0.07 mm
Layer thickness supported	0.2, 0.3 mm
Number of printing colors	3
Maximum build size (WxDxH)	- mm
Vertical print speed (max)	54000 mm/h
Minimum RAM	2 GB
Minimum processor speed	2 GHz
Mac operating systems supported	Mac OS X 10.9 Mavericks
Windows operating systems supported	Windows 7 Enterprise, Windows 7 Enterprise x64, Windows 7 Home Basic, Windows 7 Home Basic x64, Windows 7 Home Premium, Windows 7 Home Premium x64, Windows 7 Professional, Windows 7 Professional x64, Windows 7 Starter, Windows 7 Starter x64, Windows 7 Ultimate, Windows 7 Ultimate x64, Windows 8, Windows 8 Enterprise, Windows 8 Enterprise x64, Windows 8 Pro, Windows 8 Pro x64, Windows 8 x64, Windows 8.1, Windows 8.1 Enterprise, Windows 8.1 Enterprise x64, Windows 8.1 Pro, Windows 8.1 Pro x64, Windows 8.1 x64
Minimum display resolution requirement	1024 x 768 pixels
Ethernet LAN	-
Accuracy	1 %

Weight and Dimensions

Depth	581 mm
Width	566 mm
Height	606 mm
Weight	41000 g