10 Translation of Original Instructions
TO INSTALL/REMOVE THE ABRASIVE BELT
1. Disconnect the tool from the air line.
2. Hold the tool with the contact arm pointing downward. Push the contact arm against a hard surface to gain some slack until the
safety latch (A) clicks into the locking position.
3. Unfasten the set screw (B). (See Fig. 1)
B
A
(Fig. 1)
4. Rotate the belt cover (C) and replace the belt.（See Fig. 2)
(Fig. 2)
C
5. Press the safety latch (A) until the contact arm springs back to its original extended position. (See Fig. 3).
6. Rotate the belt cover into the closed position and tighten the set screw (B).
B
C
A
(Fig. 3)
To Next Page
Loading...
