North American - ENG
Date Released:
05-22-18
3M-Matic
™
Accuglide 3 - 2 Inch Taping Head - Type 10800
Page 11
44-0009-2070-0 / ECO#0078483
Figure 3-4 Tape Loading/Threading
Figure 3-5 Tape Loading/Threading
Operation (continued)
Figure 3-4
Place tape roll on tape drum to
dispense tape with adhesive side
forward. Seat tape roll fully against
back ange of drum. Adhere tape
lead end to threading needle as
shown.
Manually turn tape roll to create
slack tape while pulling threading
needle through tape applying
mechanism until needle is through
and tape is in alignment with
applying roller.
Excess tape can be cut with a
scissors at applying roller.
• To reduce the risk associated with sharp
blade hazards:
- Keep hands and ngers away from tape
cuto blades under orange blade guards.
The blades are extremely sharp.
Warning
To Next Page
Loading...
