3M 3M-Matic 8000af - Assembly Completion; Plastic Ties Removal

North American - ENG
Date Released:
October 2018
3M-Matic
™
8000af - Type 11800
Page 19
44-0009-2153-4 / ECO# 0078045
7.5 Removal of Plastic Ties
Cut the plastic which attaches the
top head to the frame and remove
the polystyrene blocks (Figure 7-4).
Cut the plastic strap which
attaches the strip and the
EMERGENCY STOP cable to the
frame (Figure 7-5). Cut the plastic
ties holding the lower taping head
in position (Figure 7-6).
7.6 Assembly Completion
1. Handle - Remove handle from
shipping position and reinstall
in operational position -
(Figure 7-7A).
2. Tape Drum Bracket - Install upper
tape drum bracket on top cross
bar as shown (Figure 7-7B).
Figure 7-5
Figure 7-6
Figure 7-4
7. Installation (continued)
Figure 7-7
A
C
B