3M 3M-Matic 8000af - Operation Warnings

North American - ENG
Date Released:
October 2018
3M-Matic
™
8000af - Type 11800
Page 27
44-0009-2153-4 / ECO# 0078045
1. Turn electrical and air supply o and disconnect before servicing taping
heads or performing any adjustments or maintenance on the machine.
Turn electrical and air supplies o when machine is not in use.
2. Do not leave machine running unattended.
3. Before turning drive belts on, be sure no tools or other objects are on the
machine bed.
4. Keep hands and loose clothing away from moving belts and  ap kicker.
5. Keep away from  ap kicker. Flap kicker is controlled by air and can be
activated (if air supply is "On") by depressing  ap kicker cam.
Be sure  ap kicker is in the down position before servicing.
6. Never attempt to remove jammed boxes from the machine while machine is
running.
7. Machine access door must be closed when drive belts are running.
Do not attempt to override door interlock switch.
8. Keep hands and clothing away from taping heads when machine is running.
A box traveling through the machine causes taping head rollers to retract
when box enters and extend as box leaves taping head.
9. Both the upper and lower taping heads utilize extremely sharp tape cut-o knives.
The Blade is located under the orange Blade guard which has the
"Warning – SHARP BLADE" label. Before loading tape, refer to Manual 2 to
identify the Blade location. Keep hands out of these areas except as necessary
to service the taping heads.
10. Failure to comply with these Warnings could result in severe personal injury
and/or equipment damage.
11.2 Operation Warnings
Warning
11. Operation (continued)