North American - ENG
Date Released:
October 2018
3M-Matic
™
8000af - Type 11800
Page 32
44-0009-2153-4 / ECO# 0078045
Notes:
1. Box drive motors are designed to run at a moderate temperature of 40° C [104° F].
In some cases they may feel hot to the touch.
2. Adjustment of the machine or taping heads are described in the "Adjustment" section
of this manual.
Important – If drive belts are allowed to
slip on box, excessive belt
wear will occur.
Figure 11-12 Box Size Setup
11.4 Box Sealing
1. Connect electrical and air supplies.
2. Turn main air valve "On" and adjust air regulator if pressure does not read 5 bar gauge
pressure [70 PSIG].
3. Press electrical "On" button to start drive belts.
4. Continually feed boxes to case sealer, case sealer will automatically space entrance of
boxes to machine.
5. Turn electrical and air supplies "O " when machine is not in use.
6. Reload and thread tape as necessary.
7. Be sure machine is cleaned and lubricated according to recommendations in
"Maintenance" section of this manual.
Figure 11-12
If the box is hard to move under the top head or is
crushed, raise the top head slightly.
If the box movement is jerky or stops under the top
head, move the side drive belts in slightly to add
more pressure between the box and drive belts.
Note: Upper head has unique feature for
overstu ed boxes. The head will raise
up to 13mm [1/2 inch] to compensate
for this type of condition.
• To reduce the risk associated with pinches and entanglement hazards:
− Do not leave the machine running while unattended.
− Turn the machine o when not in use.
− Never attempt to work on any part of the machine, load tape, or remove jammed
boxes from the machine while the machine is running.
Warning
11. Operation (continued)
To Next Page
Loading...
