North American - ENG
Date Released:
October 2018
3M-Matic
™
8000af - Type 11800
Page 31
44-0009-2153-4 / ECO# 0078045
Figure 11-11 Box Size Setup
Figure 11-10 Box Size Setup
Flap
Folding
Guides
Figure 11-10
Run several test boxes through the machine, and
observe the ap kicking action. Adjust the kicker
cam so the kicker "kicks" earlier or later as required
(refer to gure 11-10). In general, it is better to set
the kicker to "kick" early because it contacts the
ap higher above the score-line which results in
more reliable ap folding.
Figure 11-11
The upper side ap folding guides can be adjusted
in or out to accommodate the width of the box. For
optimum performance, the side ap folding guides
should be adjusted to the narrowest position which
allows them to catch any side aps that may be
bent outward past vertical.
Note – Box aps should not be bent outward
past vertical more than 15° when
entering case sealer.
• To reduce the risk associated with
impact hazards:
− Always use appropriate supporting
means when working under the upper
drive assembly
Top View
(Infeed End)
Warning
11. Operation (continued)
To Next Page
Loading...
