North American - ENG
Date Released:
October 2018
3M-Matic
™
8000af - Type 11800
Page 41
44-0009-2153-4 / ECO# 0078045
14.1 Changing Drive Belt Height
The drive belt assemblies can be raised 50mm
[2 inches] to provide better conveying of tall
boxes. This change increase minimum box
height that can be taped to 190mm [7-1/4 inches].
Disassembly – Figure 14-1
1. Using the height adjustment crank, raise
upper taping head to its fully raised position.
2. Remove and retain the M6 × 16 at head
cap screw (A), special washer (B) and
spacer (C) from the front and rear arm
assembly pivots.
3. Lift drive belt assembly (D) up o the arm
assembly pivots.
Note – Keep motor in vertical position to
prevent gear oil leaking out of motor.
Reassembly – Figure 14-2
4. Reassemble the spacer (C) onto the front
and rear arm assembly pivots rst.
5. Install the belt drive assembly (D) onto the
pivots and secure with special washers (B)
and M6 × 16 at head cap screws (A).
Note – Both drive belt assemblies must be
installed at same operating height.
A
C
D
B
Figure 14-1 Drive Belt Height,
Disassembly
Figure 14-2 Drive Belt Height,
Reassembly
• To reduce the risk associated with
pinches and entanglement hazards:
− Do not leave the machine running
while unattended.
− Turn the machine o when not in use.
− Never attempt to work on any part of
the machine, load tape, or remove
jammed boxes from the machine while
the machine is running.
A
C
D
B
Warning
14. Special Set-Up Procedure
To Next Page
Loading...
