3M Accuspray - Spray Gun Identification; Adding the PPS Components; Setting the Air Pressure

8
General Set Up and Spray Gun Use cont.
Spray GunIdentifi cation
Attach color clips into the groove on the fan and fl uid
adjustment knobs, to identify the application of the spray
gunuse.
Example of attaching airfl ow controlvalve:
1. Manually attach the air fl ow control valve to the air inlet
by hand threading theconnection.
2. Use two wrenches to connect the air fl ow control valve.
Adjust to fi t the air inlet and adjust the other to fi t the
air fl ow control valve then tighten theconnection.
Setting the AirPressure
For optimum spray performance, pull trigger back (fl uid and
air/full trigger pull) and adjust operating pressure to read 24
psi (1.6bar) for 1.2, 1.3, 1.4, 1.8 and 2.0 mm nozzles.
Note: When operating this unit, use only undamaged,
suitably solvent-resistant and appropriately pressure-rated
static-conductive air hoses.
Adding the PPS™ Components
3. Insert the 3M™ PPS™ disposable liner into the
3M™ PPS™ mixing cup.
4. Pour material to be sprayed into the 3M™PPS™
mixing cup. Stir as needed.
5.
Place the 3M™PPS™ lid with built-in fi lter on top
of the 3M™PPS™ mixing cup with liner and snap
into place.