Installation Instructions G5 - Revision C, September 2019
29
3M™ Drive-Thru System Model G5
Installation Instructions G5
Revision C, September 2019
Interpreting Display Information
Depending upon what you are doing, or what you can do, text on the display screen is handled according to the following conventions:
Buttons
Following is a brief description of the buttons on the display and their functions.
The directional arrows can be used for scrolling from one menu item to another or to scroll through available choices when editing fields.
Static or Informational Static, informational, or noneditable text has no markings on it.
<Editable, not selected> Editable items that are not currently-selected appear inside of outwardly-pointing arrows.
>Editable, Selected< Editable items that are currently selected appear inside of inwardly-pointing arrows.
>Editable, in Edit Mode< Editable items that are currently being edited have arrows pointing inwardly.
[Variable, not Editable]
Variable items that cannot be edited appear inside of square brackets. In some cases the
item is editable, but only from a different location in the menu.
{information} An on-screen explanation of a key point or reminder appears within curved brackets.
Directional arrow
buttons
You can use these buttons to scroll around when navigating the menus. When you are edit-
ing information, the up and right arrows scroll “up” (increment) and the down and left arrows
scroll “down” (decrement) a list of values.
Number/letter (0 – 9)
buttons
You can use these buttons to specify exact numbers or letters in fields that permit them.
Each time you press the button, the result changes to the next available number or letter.
For instance, pressing the 7 button three times creates a letter “t” (7-s-t). See Service button
below for creating upper-case letters.
Mode (Exit) button
In run mode, you must press the Mode key after entering your passcode to enter user or
user- or installer-level security.
In user and installation service modes, use the Mode button to exit from a current field that
you are editing without saving any changes or to go upward (backward) in the configuration
menus.
Enter (Select) buttons
(both buttons perform
the exact same
functions)
Use the Enter button to execute the current selection:
Pressing Enter on a menu opens the menu and shows you its submenu items.
Pressing Enter on an editable field switches you to edit mode so you can change the value
in the field using the arrows and number/letter buttons where applicable.
Pressing Enter while in edit mode saves the changes you have made and exits edit mode.
Service (Shift) button
Use the Service button to access upper-case letters, to initiate a service call to 3M, or as a
confirmation in some items.
Pressing and holding the Service button while editing a field that permits alphabet letter
entry (e.g., store address) shifts the letter to upper case.
In run mode, press the Service button. The Basestation will go to a Service screen used for
installation and troubleshooting.
Lane button
Use the Lane button to switch between Lane 1 and Lane 2. The Display Screen will switch
appropriately and display only those configuration settings that are available for that Lane.
This applies to the Run Screen and all Menu screens.
To Next Page
Loading...
