Installation Instructions G5 - Revision C, October 2019
5
3M™ Drive-Thru System Model G5
Installation Instructions G5
Revision C, October 2019
B
. Other Conventions
F
CC and Industry Canada Information
IMPORTANT NOTE
RF Exposure Statement:
XT-1 Headset and the 3M™ Drive-Thru Headset G5 comply with FCC RF radiation exposure limits set forth for the general public
(uncontrolled environment) per FCC, ISED and EU rules when operating based on time-averaged output power with duty cycle not
to exceed 7.63% with a minimum separation distance of 25 mm from all persons. The wireless system must not be co-located or
operating in conjunction with any other antenna or transmitter.
The G5 Basestation Model G5B1 complies with FCC, ISED and EU radiation exposure limits. This equipment should be installed and
operated with a minimum distance of 20 cm between the radiator and your body. This includes any 3M-approved external antenna.
To ensure that the maximum 20 dBm EIRP output power is not exceeded for any 3M-approved external antenna that is used with the
G5 Basestation Model G5B1, the minimum length of RF cable required is 100 feet.
The use of accessories not approved by 3M Company (including, but not limited to, batteries, antennas, wall adapters, chargers, ear
pads, foam tips and convertible covers) may cause your headset or Basestation to malfunction, or in the case of unapproved
electrical accessories and antennas, may cause the devise to exceed RF energy exposure guidelines.
FCC Note:
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own
expense.
Canada Note: CAN ICES-3 A/NMB-3 A
This device complies with part 15 of the FCC Rules and with Industry Canada license-exempt standard RSS-210 as of the date
printed. Operation is subject to the following two conditions: (1) this device may cause interference, and (2) this device must accept
any interference, including interference that may cause undesired operation of the device.
Cet appareil est conforme avec la norme RSS-210 d'Industrie Canada exempte de licence à compter de la date imprimée. Son
fonctionnement est soumis aux deux conditions suivantes : (1) cet appareil peut causer des interférences, et (2) cet appareil doit
accepter toute interférence, y compris celles pouvant provoquer un fonctionnement indésirable de l'appareil.
To Next Page
Loading...
