44
Installation Instructions G5 - Revision C, September 2019
3M™ Drive-Thru System Model G5
Q. Split- and Cross-Lane Mode
In any Dual-Lane installation (tandem, side-by-side, or dual drive-thrus), the system can be configured to operate registered headsets in
Split- or Cross-Lane Mode. The difference between Split-Lane and Cross-Lane modes in this situation is:
• Split-Lane mode is intended for a drive-thru with two order takers. Each order taker hears beeps only for the lane for which the
headset is configured. Beeps from the other lane will not be heard.
• Cross-Lane mode is intended for a drive-thru with one order taker who will hear beeps for both lanes on one headset. You can
configure the system to permit non-order takers to hear orders and pages from one or both sides. See “Order Takers and Page
Messages in Cross-Lane Mode” on page 40.
R. Installer Setup
Installer setup is a special group of setup options typically only used by the installer.
Load Installation Settings
Installation settings are a complete set of configuration data that the installer can save after the initial installation configuration is completed.
It is essentially a backup save point in case configuration settings are inadvertently changed in ways that are not easy to identify or correct.
To load the installation settings:
By performing this procedure, you will be erasing the current configuration and reloading the configuration that was last saved, likely
when the system was first installed.
• Enter the configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Select 14 Installer Setup.
• Change the value for Load Installation Settings to Yes.
• The system will then reboot.
Save Installation Settings
This function is only available to installers.
Perform the following procedure to save the current configuration into permanent memory over the existing installation settings:
By performing this procedure you will be erasing the existing saved installation settings, making it impossible to revert to the settings
that were saved after installation.
• Enter the configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Select 14 Installer Setup.
• Change the value for Save Installation Settings to Yes.
To Next Page
Loading...
