3M Drive-Thru G5 - C. Finding the MAC Address of the G5 Basestation; D. Configuring with a Computer

30 Installation Instructions G5 - Revision C, September 2019
3M™ Drive-Thru System Model G5
C. Finding the MAC Address of the G5 Basestation
To find the MAC address of the G5 Basestation.
• Enter the configuration mode (see “Enter Configuration Mode” on page 28) and choose 1 System Menu.
• Select 16 Network Setup.
• Note the six pairs of alpha-numeric characters (enclosed in square brackets), against the MAC Address field.
Note that your G5 Basestation may contain a different set of characters than the one illustrated below:
Figure 24.
D. Configuring with a Computer
All of the procedures in this chapter assume that you are using the display to configure your Basestation(s). However, the Basestation can
function as a web server, which means it can be configured using a PC. The web server functionality is enabled on the Basestation by default.
To set up web server functionality:
1. Connect the Basestation:
a. Peer-to-Peer – a direct connection between the Basestation and the PC using a crossover cable.
b. Private network – a connection between the Basestation and a router, switch or hub using an Ethernet cable. The PC is somewhere
on the same network.
2. Enter the configuration mode (see "Enter Configuration Mode" on page 28), and choose 1 System Menu.
3. Select 16 Network Setup.
4. Change the values for IP address, Subnet Mask, and Default Gateway, according to the table below.
5. Reboot system. See “Reboot System” on page 45.
6. Enter the configuration mode.
7. Select 16 Network Setup.
8. Verify the values for Web Server Enabled is Yes, or else change this value to Yes.
9. Reboot system. See “Reboot System” on page 45.
Setting If Peer-to-Peer If Private Network
IP Address
Basestation 192.168.99.2
192.168.0.110
(or another unused address in the same address
space as the DHCP address)
PC 192.168.99.1 DHCP
Subnet Mask
Basestation 255.255.255.0 255.255.255.0
PC 255.255.255.0 No requirement
Default Gateway
Basestation 192.168.99.1
192.168.0.1
(or the switch, router, or hub address)
PC Leave blank
192.168.0.1
(or the switch, router, or hub address)