3M Drive-Thru G5 - 11. Appendix: Upgrading a Single-Lane Basestation to a Dual-Lane

Installation Instructions G5 - Revision C, September 2019 67
3M™ Drive-Thru System Model G5
Installation Instructions G5
Revision C, September 2019
11. Appendix: Upgrading a Single-Lane Basestation to a Dual-Lane
A 7-digit code is necessary in order to upgrade the software on the Single-Lane G5 Basestation to enable the Dual-Lane capabilities. This
7-digit code is unique to each Basestation and is based on the MAC IP Address. Once the 3M™ Drive-Thru System G5 Dual-Lane Upgrade
Package SKU#78-6911-5206-6 / SAP ID 7100163200 has been purchased, you will need to provide the following information to 3M in
order to receive the upgrade code:
Customer (Store) Name:
Street address: City: State: Zip:
Basestation Serial #:
MAC Address: 
-  -  -  -  - 
To find the MAC address of the G5 Basestation, enter the configuration mode and choose 1 System. Then select 16 Network Setup. You will see 6 pairs of
alpha-numeric characters enclosed in square brackets following the words MAC ADDRESS. Please put those 12 alpha-numeric characters in the boxes above
in the order as shown on the Basestation menu screen.
3M Invoice # used to purchase the Upgrade Software: PZ
3M Invoice Date:
Once you have completed the information above, please call 3M at 800-328-0033 and select Option 1, option 3. Or you can email this
information to tacsupport@mmm.com.
After you receive the 7-digit code from 3M, go to the G5 Basestation Main Menu Screen:
Figure 30.
From the Main Menu Screen:
1. Enter the 7-digit code you received from 3M on the keypad.
2. Press Mode key and the base station display will indicate it has been upgraded.
3. Enter the installer pass code 12345 on the keypad and press Mode key twice.
4. Select the System Menu and press Enter.
5. Press arrow down to “14 Installer Setup” and press Enter.
6. Select “Save Installation Settings”, Toggle to Yes and press Enter.
7. Press arrow down to the 3rd page to “Number of Lanes at This Site”, press Enter, press Arrow up and then press Enter.
8. The number of Lanes at this site will now show “2”.
9. Press Mode key 3 times to return to the main menu.
Changing Your Settings
From the Main Menu Screen:
1
. Enter the installer pass code 12345 on the keypad and press Mode key twice.
2. Select the System Menu and press Enter.
3. Select “1 Drive-Thru Volume” and press Enter.
4. Once settings are complete for Lane 1, press Lane key in order to change to Lane 2.
5. If you need to set up a Tandem Lane, Select “7 Global Settings”, switch to Lane 2 and turn on “Please Pull Ahead” Message.
6. Press Mode key 3 times to return to the Main Menu.