3M Drive-Thru G5 - B. Navigating the Basestation Display

28 Installation Instructions G5 - Revision C, September 2019
3M™ Drive-Thru System Model G5
3. Configuration
A. Enter Configuration Mode
Configuration mode is a passcode-protected area that contains most of the configuration options for the Basestation system. Using the
access provided for users, it is possible to set up all of the functionality of the system.
To enter the configuration mode:
• From the Run mode menu.
• Enter your user passcode.
• Press Mode. The display will show the user name and ID number (e.g., User1 ID = 1).
• Press Mode again. The display will show the Main Menu with options to select 1 System Menu or 2 Greeter Menu.
Figure 23.
IMPORTANT NOTE
i
There are two levels of passcode: installers and users. Using a user’s passcode permits you into all system menu items except those
reserved for installers.
The default user password is 1234.
The default installer password is 12345.
B. Navigating the Basestation Display
Once you are in the configuration mode, you can use the buttons on the Basestation display to update all configuration parameters.