40
Installation Instructions G5 - Revision C, September 2019
3M™ Drive-Thru System Model G5
This option is available on Lane 2 settings only. Perform the following procedure to enable or disable the automatic pull ahead for
Order Point #2:
• Enter the Basestation user service mode, see “Enter Configuration Mode” on page 28, and choose 1 System Menu.
• Press the Lane button.
• Change the value for 07 Global Settings > ’’Pull Ahead’’ Prompt (Tandem Only)? to Yes or No.
Customer Order Point Prompt Language
Perform the following procedure to select the language(s) of the store closed and pull ahead prompts. The prompts can be spoken in English,
Spanish, French, German, or repeated in multiple languages:
• Enter the Basestation configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Change the value for 07 Global Settings > Order Point Prompts in English? to Yes or No.
• Press Enter to implement the change or press Mode to abandon the change and leave the option at its previous setting.
• Change the value for 07 Global Settings > Order Point Prompts in Spanish? to Yes or No.
• Press Enter to implement the change or press Mode to abandon the change and leave the option at its previous setting.
• Change the value for 07 Global Settings > Order Point Prompts in French? to Yes or No.
• Press Enter to implement the change or press Mode to abandon the change and leave the option at its previous setting.
• Change the value for 07 Global Settings > Order Point Prompts in German? to Yes or No.
Order Takers and Page Messages in Cross-Lane Mode
In systems with two customer order points, in Cross-Lane mode, you must specify the number of order takers you will be using to make
sure that non-order takers can hear orders being taken on one or both lanes. Similarly, you must specify whether you want page messages
to be heard by all headsets or only within each lane.
Perform the following procedure to specify the number of order takers in cross lane mode.
• Enter the Basestation configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Change the value for 07 Global Settings > Order Takers in CROSS Lane Mode? to 1 or 2.
• If you select 1, non-order takers will hear the orders from Lanes 1 and 2.
• If you select 2, non-order takers will hear only the orders on the lane for which the headset is configured.
Perform the following procedure to enable or disable paging to be heard by operators on both lanes.
• Enter the Basestation configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Change the value for 07 Global Settings > PAGE Messages Can Cross Lanes? to YES or NO.
Order Point TALK with No Vehicle
Perform the following procedure to permit or prevent the order taker to talk to the order point when no vehicle is detected.
• Enter the Basestation user service mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Change the value for 07 Global Settings > Order Point TALK With No Vehicle? to Yes or No.
Detector Type
Because there are two basic types of vehicle detector, pulse and presence, you must specify which type you have in the Basestation.
• Enter the Basestation configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Change the value for 07 Global Settings > Vehicle Detector#1 to Presence or Pulse.
To Next Page
Loading...
