34
Installation Instructions G5 - Revision C, September 2019
3M™ Drive-Thru System Model G5
Outbound Talk Volume
Changing the outbound talk volume affects the volume of the speaker at the customer order point.
To avoid feedback, set the outbound talk volume as low as possible.
To change the outbound talk volume:
• Enter the configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Select a new value for 01 Drivethru Volume > Outbound Talk Volume. The range is 0 (silent) to 20 (max).
Vehicle Alert Volume
Changing the vehicle alert volume affects the volume of the vehicle alert signal on the headsets.
To change the vehicle alert volume:
• Enter the configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Select a new value for 01 Drivethru Volume > Vehicle Alert Volume. The range is 0 (silent) to 20 (maximum).
Outbound Greeter Message Volume
Changing the outbound Greeter message volume affects the sound volume of the custom greeting messages and the system internal
greetings (“Store Closed” and “Pull Forward”).
To turn the Greeter message volume up or down:
• Enter the configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Select a new value for 01 Drivethru Volume > Outbound Greeter Message Volume. The range is 0 (silent) to 20 (max).
Change the Monitor Volume
The monitor is an additional speaker that can be used to follow drive-thru communication without a headset, typically in the kitchen. If the
monitor has a volume control built into it, you can use it to control the overall volume level of the speaker. To be more specific about which
elements you want to control, follow the instructions in the following sections.
Inbound Listen
Changing the inbound listen volume affects how loudly the monitor plays the inbound (customer order point) communication. You can also
disable inbound sounds on the monitor.
To change the inbound listen monitoring settings:
• Enter the configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Select 02 Monitor Volume.
• To enable or disable inbound sounds on the monitor, change the value for Inbound Listen: Enable to ON or OFF.
• To change the volume level, select a new value for Inbound Listen: Volume. The range is 0 (silent) to 20 (maximum).
Outbound Talk
Changing the outbound talk volume affects how loudly the monitor plays the outbound (order taker) communication. You can also disable
outbound talk on the monitor.
To avoid feedback and echo, set the outbound talk volume as low as possible.
To change the outbound talk monitoring settings:
• Enter the configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Select 02 Monitor Volume.
• To enable or disable outbound talk on the monitor, change the value for Outbound Talk: Enable to ON or OFF.
• To change the volume level, select a new value for Outbound Talk: Volume. The range is 0 (silent) to 20 (maximum).
To Next Page
Loading...
