Installation Instructions G5 - Revision C, September 2019
35
3M™ Drive-Thru System Model G5
Installation Instructions G5
Revision C, September 2019
Vehicle Present
Changing the vehicle present volume affects how loudly the monitor plays the vehicle present tone. You can also disable the vehicle present
tone on the monitor.
To change the vehicle present monitoring settings:
• Enter the configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Select 02 Monitor Volume.
• To enable or disable the vehicle present tone on the monitor, change the value for Vehicle Present: Enable to ON or OFF.
• To change the volume level, select a new value for Vehicle Present: Volume. The range is 0 (silent) to 20 (maximum).
Vehicle Approach
Some sites are equipped with a vehicle approach detector, which alerts you when a vehicle enters the parking lot or drive-thru approach
lane. If your site is equipped with the detector, you can change the volume at which the tone is played on the monitor. Also, if you do not
wish to hear the tone, you can disable it.
To change the vehicle approach monitoring settings:
• Enter the configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Select 02 Monitor Volume.
• To enable or disable the vehicle approach tone on the monitor, change the value for Vehicle Approach: Enable to ON or OFF.
• To change the volume level, select a new value for Vehicle Approach: Volume. The range is 0 (silent) to 20 (maximum).
Page Messages
Paging is headset-to-headset communication. Changing the page message volume affects how loudly the monitor plays internal paging
messages. You can also disable internal paging messages on the monitor.
To avoid feedback and echo, set the volume as low as possible.
To change the page message volume monitoring settings:
• Enter the user service mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Select 02 Monitor Volume.
• To enable or disable internal paging messages on the monitor, change the value for PAGE Messages: Enable to ON or OFF.
• To change the volume level, select a new value for PAGE Messages: Volume. The range is 0 (silent) to 20 (maximum).
Greeter Messages
Changing the Greeter message volume affects how loudly the monitor plays the Greeter messages. You can also disable Greeter messages
on the monitor.
To change the Greeter message volume monitoring settings:
• Enter the configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Select 02 Monitor Volume.
• To enable or disable Greeter messages on the monitor, change the value for Greeter Messages: Enable to ON or OFF.
• To change the volume level, select a new value for Greeter Messages: Volume. The range is 0 (silent) to 20 (maximum).
Monitoring Audio Separately for the Two Lanes
The “Lane Monitor Outputs” option only appears when the Basestation is operating in a Dual-Lane. It has two choices – “Mixed” or
“Separate”.
In Mixed mode, all Monitor audio from both Lanes 1 and 2 are played on the single Speaker.
In Separate mode, if you have hooked up two separate speakers for the two lanes, then traffic on Lane 1 is played on Speaker 1, and traffic
from Lane 2 is played on speaker 2.
To Next Page
Loading...
