3M HCD-1 - Control Panel Buttons - Part 2; HOW TO USE; INSTRUCTION BEFORE USE

5.
Cold Water
•
Function 1: Switch
•
Function 2:
6.
Power
• Switch
on/off the dispenser.
7.
Safety
Lock
•
Lock/unlock hot water dispensing lever.
•
At standby mode, tap once to unlock the lever (red indicator lights up).
8.
Cold Water Temperature
• Indicate
s
9.
Hot Water Temperature
• Indicate
s
10.
Water Level
(GREEN)
•
Indicates the water level in the filtered water tank.
HOW TO USE
INSTRUCTION BEFORE USE
1.
Ensure that the water hose is connected to the dispenser.
2.
Turn on the water supply valve.
3.
Check for any water leakage. Do not proceed if leakage occurs.
4. Plug in the power cord.
5. Press the power button.
6.
Check the water level indicator. Dispense only if the indicator is lit.
8
Function 1: Switch
on/off the cold water function.
Function 2:
Adjust and set cold water temperatures.
on/off the dispenser.
Lock/unlock hot water dispensing lever.
At standby mode, tap once to unlock the lever (red indicator lights up).
Cold Water Temperature
(BLUE)
s
cold water temperature levels.
Hot Water Temperature
(RED)
s
hot water temperature levels.
(GREEN)
Indicates the water level in the filtered water tank.
INSTRUCTION BEFORE USE
Ensure that the water hose is connected to the dispenser.
Turn on the water supply valve.
Check for any water leakage. Do not proceed if leakage occurs.
Check the water level indicator. Dispense only if the indicator is lit.
At standby mode, tap once to unlock the lever (red indicator lights up).