3M SCOTT AIR-PAK X3 PRO - Attaching the Shoulder Harness and Waist Pad

SOFT GOODS ASSEMBLY & DISASSEMBLY
32 P/N 595360-01 Rev G 202004
5 Remove the waist-to-shoulder straps from each side of the backframe and set aside.
a From the rear of the backframe, locate the tri-slide securing the waist-to-shoulder straps to the backframe.
b Pull the tri-slide away from the backframe until the opposite end of the waist-to-shoulder strap can be fed
through the backframe slot. See Figure 2-15.
c Repeat for the other side.
Figure 2-15 Removing the waist-to-shoulder straps from the backframe
Attaching the Shoulder Harness and Waist Pad
To attach the waist pad to the backframe
1 Attach the waist-to-shoulder straps to the backframe.
a Grasp the folded end of a waist-to-shoulder strap. See Figure 2-16.
Figure 2-16 Grasping the folded end of the waist-to-shoulder strap.
b With the sewn side facing up, feed the waist-to-shoulder strap through the backframe slot (starting front to
back) until the tri-slide is flush against the backframe. See Figure 2-17.
Tri-slide
Pull tri-slide away from
backframe
Folded end of strap,
sewn side facing up