3M
TM
Sound Detector SD-200
SD-200: dangers, warnings, cautions & battery
Danger!
Failure to observe the following procedures may result in serious personal
injury
• Not for use in explosive or hazardous locations. This product is not intrinsically safe.
• Contains built-in lithium polymer battery. Do not incinerate or dispose of in fire. Do not
disassemble, alter, or re-construct.
Warning!
Failure to observe the following procedures could damage the instrument
• Read the manual before operation.
• Do not store in temperatures exceeding 70°C (158°F).
• Do not immerse in liquids.
• Condensation may damage your instrument.
• Substitution of components may impair the accuracy of the instrument. Repair should be
done by authorized service personnel only.
Caution!
General
• The battery in this instrument has limited shelf-life, even if never used.
• A non-condensing environment is required for proper measurements.
• Do not charge battery outside the range of 0°C to 40°C (32°F to 104°F).
• Battery run-time may be reduced when operating at lower than 0°C (32°F) temperatures.
Battery power and first use recommendation
It is recommended to fully charge the SD-200 for approximately 12 hours prior to
first use.
Intended Use:
The SD-200 is intended to measure sound pressure levels in air. Consult your
company’s safety professional for local standards, or call 3M at 1-800-243-4630.
To Next Page
Loading...
Need help?
General
