3M Steri-Vac GS8 - EMC Compliance

4
70-2011-5643-0 Issue Date: 10/2015
3M
™
Steri-Vac
™
Sterilizer/Aerator GS Series
Site Planning and Installation Guide
Note: This equipment has been tested and found
to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide a reasonable protection against
harmful interference when the equipment is operated
in a commercial environment. This equipment
generates and can radiate radio frequency energy
and, if not installed and used in accordance with this
document and the 3M
™
Steri-Vac
™
Sterilizer/Aerator
GS Series Operator Manual, may cause harmful
interference to radio communications. Operation of
this equipment in a residential area is likely to cause
harmful interference in which case the purchaser
will be required to correct the interference at their
own expense. In addition, operation of this device
may accept any interference received, including
interference that may cause undesired operation.
I. Introduction (continued)
EMC Compliance
The 3M
™
Steri-Vac
™
Sterilizer/Aerator GS Series complies with the following EMC standards as
confirmed in the Certificate of Compliance generated by 3M:
• IEC 61326-1. Electrical equipment for measurement, control and laboratory use - EMC requirements
- Part 1: General requirements.
• EMC requirements of the CE mark EMC Directive 2004/108/EC.
• Australian EMC requirements as confirmed in the Supplier’s Declaration of Conformity that is linked
to the RCM Mark.
• As a Class A digital apparatus meeting all requirements of the Canadian Interference-Causing
Equipment Regulations.
See ANNEX E for a complete list of related compliance standards for the 3M
™
Steri-Vac
™
Sterilizer/Aerator GS Series.