What to do if there is an L4 error after EO gas is in the chamber for 3M Steri-Vac GSX Laboratory Equipment?
If an L4 error occurs after EO gas is in the chamber, a Supervisor or Service personnel must clear the error. Wait until the Stop button is red. The Supervisor or Service personnel should press Stop Cycle and enter the PIN, then press Clear and enter the PIN to clear the error. Remember to document everything per facility procedures.
How to clear L1 error before EO gas in chamber for 3M Steri-Vac GSX?
To clear an L1 error that occurs before EO gas is in the chamber, the operator can clear the error and access the load. First, wait until the Open Door or Open Load Door button is blue. Then, press Open Door and press Clear to clear the error. Make sure to document everything per facility procedures and restart the cycle per facility procedures.
What to do if there is a C604 power interruption in 3M Steri-Vac GSX Laboratory Equipment?
In the event of a C604 power interruption, document the issue per facility procedures.
What to do if there is an E702 user abort error on 3M Steri-Vac GSX Laboratory Equipment?
If an E702 user abort error occurs, clear the details.
What to do if 3M Steri-Vac GSX shows an L2 error before EO gas, requiring service?
If an L2 error occurs before EO gas is in the chamber and requires service, the operator can access the load. Wait until the Open Door or Open Load Door button is blue, then press Open Door. Call Service, as Service must clear the error. Be sure to document the issue per facility procedures and restart the cycle per those procedures.
What to do if 3M Steri-Vac GSX has an L5 error after EO gas requiring service?
If an L5 error occurs after EO gas is in the chamber and requires service, call Service. Service must access the load and clear the error. Remember to document everything per facility procedures.
What should I do if there's an L6 error after EO gas in the chamber, requiring service attention for 3M Steri-Vac GSX Laboratory Equipment?
If an L6 error occurs after EO gas is in the chamber and requires service attention, call Service. Service must access the load and clear the error. Document the issue per facility procedures.
What to do when 3M Laboratory Equipment shows A2 errors in temperature control during programmed aeration?
If A2 errors occur in temperature control during programmed aeration, call Service. Service must access the load and clear the error. Document per facility procedures.
What to do if there is an L3 error before EO gas requiring service for 3M Steri-Vac GSX?
If an L3 error occurs before EO gas is in the chamber, requiring service before the operator can open the load door, call Service. Service must access the load and clear the error. Document the issue and restart the cycle per facility procedures.
What to do when 3M Steri-Vac GSX Laboratory Equipment has L7 errors requiring 3M Service?
If L7 errors occur requiring 3M Service, call Service. Service must clear the error. Document per facility procedures.
General| Brand | 3M |
|---|---|
| Model | Steri-Vac GSX Series |
| Category | Laboratory Equipment |
| Language | English |
To Next Page